P22BB
O2 Sensor Reference Voltage Circuit/Open (Bank 2 Sensor 2)
P22BB reports an open reference voltage line on the bank 2 downstream wide-band probe, meaning the controller has lost the Nernst-cell signal (RE/UN on Bosch, VS on NTK) it needs to regulate pump current and compute oxygen content. No maker documents this code publicly. For the upstream bank 2 relative P2247, Ford flags an open reference lead once the sensor voltage leaves 0.2-4.7 V for 10 s, and VW's 2014 Touareg data book calls the same fault an open Nernst voltage below 0.25 V or above 4.80 V with cell resistance over 950 ohms. Its bank 1 twin P22AE is listed by Chrysler for the 6.7 Cummins Ram. Only engines with two exhaust banks and a wide-band probe after each catalyst can set it. P22BC-P22BE are the performance/low/high siblings. The lamp comes on.
Possible causes
- Corroded or loose Nernst-cell terminal in the connector high
- Reference wire broken in the harness medium
- Cracked sensing cell or internal open in the sensor medium
Symptoms
- Check engine light
- Bank 2 downstream oxygen value invalid
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22BB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.