P22B9
O2 Sensor Positive Current Control Circuit Low (Bank 2 Sensor 2)
P22B9 means the positive current control (pump-current) line of the bank 2 downstream wide-band probe reads below its allowed band, most often because the lead has worn through and touches ground. No maker documents this code publicly, so the logic can only be inferred from the bank 1 and upstream relatives: GM lists P22AC for the 3.0 Duramax LM2 without a threshold, Saab treats the upstream P2238 as a Type B fault, and Ford books upstream shorts as P0131. CARB requires out-of-range detection on air-fuel sensors behind the aftertreatment. The fault needs a V or boxer engine with a wide-band probe after each catalyst. P22B8 is the open, P22BA the high variant, P22AC the bank 1 code. A lit warning lamp is usually the only symptom.
Possible causes
- Pump-current wire chafed through and shorted to ground high
- Internal short in the bank 2 downstream sensor medium
- Water in the connector low
Symptoms
- Check engine light
- Bank 2 downstream oxygen value at an extreme
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22B9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.