P22B4
O2 Sensor Negative Current Control Circuit High (Bank 1 Sensor 2)
P22B4 is stored when the negative current control line (virtual ground) of the bank 1 downstream wide-band probe climbs above its intended bias. Because this return sits at a mid-level voltage rather than at chassis ground, a short to the heater feed or battery voltage is the classic trigger, sometimes via moisture or a heat-damaged connector. No maker documents this exact code publicly; Mitsubishi lists the upstream analog P2253 as a two-trip code for the 2022 Outlander, while Ford treats upstream shorts to power as P0132. CARB asks for detection of out-of-range values on such sensors. P22B2 is the open, P22B3 the low variant, P22C1 the bank 2 code. The lamp is on and the related emission monitors will not complete.
Possible causes
- Return wire shorted to heater supply or battery voltage high
- Heat-damaged or wet connector bridging pins medium
- Internal heater-to-cell leakage in the sensor medium
Symptoms
- Check engine light
- Downstream oxygen reading erratic or at a limit
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22B4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.