P22B1
O2 Sensor Reference Voltage Circuit High (Bank 1 Sensor 2)
P22B1 is set when the reference voltage (Nernst-cell) line of the bank 1 downstream wide-band probe reads above its valid range. Because the cell delivers only a few hundred millivolts across about 300 ohms, any contact with the heater feed or another live wire overrides it. A cracked ceramic letting the heater circuit leak into the cell can do the same. No maker publishes this code with a threshold; for the upstream sensor, Ford and Saab already treat a voltage above 4.7 V as an open reference line, while Ford sends shorts to power to P0132. CARB demands detection of out-of-range values on air-fuel sensors behind the aftertreatment. P22AE covers the open, P22B0 the low reading, P22BE bank 2 and P2246 the upstream twin.
Possible causes
- Nernst-cell wire shorted to the heater supply or another live wire high
- Cracked sensor ceramic leaking heater voltage into the cell medium
- Faulty sensor interface in the ECM or sensor module low
Symptoms
- Check engine light
- Downstream oxygen reading stuck at a limit
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22B1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- bosch-motorsport.com/content/downloads/Raceparts/Resources/pdf/Data Sheet_69034379_Lambda_Sensor_LSU_4.9.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626