P22AF
O2 Sensor Reference Voltage Performance (Bank 1 Sensor 2)
P22AF is a plausibility fault on the Nernst-cell (reference voltage) side of the bank 1 downstream wide-band probe: the wiring is intact, but the cell signal does not behave as the controller expects, for instance it cannot be held at its set point or drifts. Typical reasons are an aged cell whose resistance has risen above the roughly 300 ohms Bosch quotes for the LSU 4.9, soot or oil deposits, or a heater that keeps the element too cool. No maker documents this code publicly. CARB requires the OBD system to catch deterioration of voltage, impedance, current or offset of air-fuel sensors behind the aftertreatment before emissions rise too far. Siblings: P22AE open, P22B0/P22B1 low/high, P22BC bank 2, P2244 upstream.
Possible causes
- Aged downstream wide-band sensor with raised cell resistance high
- Soot, oil or coolant deposits on the sensing element medium
- Weak heater or heater control that leaves the element too cold low
- High-resistance contact in the Nernst-cell circuit low
Symptoms
- Check engine light
- Downstream oxygen reading sluggish or offset compared with the upstream sensor
- Catalyst or aftertreatment monitor may report errors as a follow-up
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22AF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.