P22AD
O2 Sensor Positive Current Control Circuit High (Bank 1 Sensor 2)
P22AD is the high-side fault on the positive current control line of the bank 1 downstream wide-band probe: the pump-current wire is pulled above its expected level, for example by contact with the heater feed or another supply wire. On Saab's 2010 9-5 the pump-current pins measure roughly 2.8 V at the plug, which gives a feel for the normal bias. GM lists the code in bulletin 21-NA-149 for the 3.0 Duramax LM2, again tied to engine harness chafing, but publishes no limit. Ford sends shorts to power on its upstream wide-band probes to P0132 instead of a dedicated code. The upstream analog is P2239 (Type B at Saab); P22AB is the open circuit, P22AC the low reading, P22BA the bank 2 version. The lamp is lit; driving normally feels unchanged.
Possible causes
- Pump-current wire shorted to the heater supply or another positive feed high
- Internal short between heater and pump cell in the sensor medium
- Faulty sensor interface in the ECM or sensor module low
Symptoms
- Check engine light
- Downstream oxygen reading implausibly high or fixed
- Readiness monitors for catalyst or aftertreatment not completed
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22AD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- static.nhtsa.gov/odi/tsbs/2022/MC-10224856-0001.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2