P22A0
NOx Sensor Circuit Low (Bank 1 Sensor 2)
P22A0 reports that the rear NOx sensor on bank 1 sends a raw value below the smallest figure a healthy sensor can produce. Because the sensor talks over CAN, the test looks at the transmitted number rather than a wire voltage. GM uses minus 90 ppm on the 6.6L LML, on its 2017 small diesels (table 17OBDG04) and on the 3.0L LZ0, in each case Type B after two trips with dew point reached and supply in range; the LZ0 needs 100 failed samples in 200. VW's 2014 Touareg TDI faults below minus 105 ppm or a lambda signal under minus 0.2. GM bulletin 24-NA-094 puts P22A0 on the list cured by an LZ0 software update on 2024 Silverado and Sierra 1500. A strongly negative value usually means element drift or an internal fault. P22A1 is the upper limit, P2202 the front sensor.
Possible causes
- Outlet NOx element drifted low or internally faulty high
- Engine software anomaly (GM 3.0L LZ0 2024, bulletin 24-NA-094) medium
- Damaged lead between probe and sensor module low
Symptoms
- Malfunction indicator lamp on after two trips
- Live data shows a negative downstream NOx value
- SCR efficiency monitor does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22A0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.