OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P229B

Fuel Pressure Regulator B Exceeded Control Limits - Pressure Too High

P229B flags rail pressure that stays above target while fuel pressure regulator B should be holding it. GM's 2018 diesel table, where regulator B is the rail pressure regulator valve, runs this check with the valve in closed-loop control and under the same enable conditions as P229A (fuel level, ambient pressure and temperature), mirroring the overpressure test P228D of the metering unit, and rates it Type B. A valve that sticks closed or cannot open far enough, a drive signal that keeps it energised, or a rail pressure sensor reading high are the classic causes. If pressure keeps climbing to the absolute ceiling, P2293 follows. P229A is the deficit case, P228D the same fault seen through regulator A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 9B

Possible causes

  • Rail pressure regulator valve sticking closed high
  • Rail pressure sensor reading too high medium
  • Valve drive signal stuck on (wiring or module) low

Symptoms

  • Check engine light
  • Harder combustion noise
  • Reduced power in some cases

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P229B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication