OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2294

Fuel Pressure Regulator B Control Circuit/Open

P2294 is the open-circuit check of the drive line to fuel pressure regulator B. GM's 2018 diesel ECM tests the low-side driver of the rail pressure regulator valve while the output is switched off: a voltage indicating more than 200 kΩ between signal and ground counts as open, and 44 failures in 88 samples at 6.25 ms set the code as Type B. VW's 2014 Passat quick reference uses a signal voltage between 1.40 and 3.20 V or an implausible signal pattern. Broken wires, a pushed-back connector pin or an interrupted valve coil are the usual findings. Without control of the valve the ECM cannot release rail pressure as intended and may limit power. P2295 and P2296 split shorts to ground and to supply.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 94

Possible causes

  • Broken wire in the regulator harness high
  • Loose, corroded or pushed-back connector pin medium
  • Open coil in the pressure regulator valve medium
  • Faulty output driver in the engine control module low

Symptoms

  • Check engine light
  • Reduced power or emergency mode
  • Unstable idle or hard starting

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2294

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication