OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P228B

Fuel Pressure Regulator B - Forced Engine Shutdown

P228B mirrors P228A but concerns fuel pressure regulator B, which in GM's 2018 diesel calibration is the rail pressure regulator valve that spills surplus fuel from the rail. The ECM shuts the engine down when rail pressure stays more than 40 MPa below target although it already commands that valve fully closed, judged over 640 of 800 samples at 12.5 ms and stored as Type A. A fully closed spill valve should trap everything the pump delivers, so a remaining deficit points to a valve leaking internally, a weak pump, a starved supply (GM bulletin 18-NA-103: gelled diesel, together with P228A and P0087) or excessive injector leakage. P229A is the non-shutdown deviation check of the same regulator.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 8B

Possible causes

  • Rail pressure regulator valve not sealing when closed high
  • Fuel starvation from gelled diesel or a blocked filter medium
  • High-pressure pump delivering too little medium
  • Excessive injector leak-off low

Symptoms

  • Engine stops on its own and may not restart
  • Check engine light with low rail pressure codes
  • Loss of power just before the shutdown

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P228B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication