P2285
Injector Control Pressure Sensor Circuit Low
P2285 is set when the ICP sensor voltage falls almost to zero. Ford's 6.0L Power Stroke summaries for 2003 and 2004 define it precisely: below 0.03 V, checked every 8 ms without entry conditions, decided in under one second. Such a value cannot come from a working sensor on a 5-volt reference, so it points to an open signal wire, a short to ground, a lost reference voltage or an unplugged sensor. Ford lights the MIL for P2285 even on heavy federal trucks over 8,500 lb that otherwise run a reduced OBD calibration. On a HEUI engine the PCM then has to estimate rail pressure, so starting and response deteriorate. P2286 is the high-voltage counterpart; P2284 covers a valid signal that disagrees with the commanded pressure.
Possible causes
- Signal wire open or shorted to ground high
- Sensor disconnected or failed internally medium
- Missing 5-volt reference supply medium
Symptoms
- MIL on immediately
- Hard starting and reduced power
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2285
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.