OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2283

Injector Control Pressure Sensor Circuit

P2283 is the general circuit code for the injector control pressure (ICP) sensor. ICP describes the high-pressure engine oil that hydraulically actuated unit injectors (HEUI) use to pressurise fuel, as on Navistar-built Ford Power Stroke diesels; the sensor reports rail pressure so the injection pressure regulator can be closed-loop controlled. No manufacturer documents P2283 publicly. Ford's 6.0L summaries for 2003 and 2004 split the electrical check into P2285 (below 0.03 V) and P2286 (above 4.83 V), and Ford's 2014 PCM code table lists those two but not P2283. CARB requires diesel fuel-pressure control, explicitly including hydraulic fluid, to be monitored. Without a valid ICP signal the PCM substitutes a default value, so power and starting suffer.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 83

Possible causes

  • Failed ICP sensor, often with oil inside the connector high
  • Damaged signal, reference or ground wire of the sensor medium
  • 5-volt reference circuit pulled down by another sensor low

Symptoms

  • Low power and hesitation
  • Hard or long cranking, especially when hot
  • MIL on

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2283

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication