P227E
Barometric Pressure Sensor C Circuit Intermittent/Erratic
P227E covers a sensor C signal that jumps although every single value is in range. GM measures this as a string length: the absolute difference between each reading and the one taken 12.5 ms earlier is summed over 80 consecutive readings, and a sum above 152 kPa (2018 diesel) or 150 kPa (supercharged LT4) counts as a failure. Four failures in five one-second samples set the code, as Type B with two trips on the diesel and as Type A on the LT4. Loose terminals, chafed insulation, a cracked sensor housing or interference from nearby actuators are typical triggers. P227C and P227D catch steady shorts, P227B values that are smooth but wrong. The engine normally keeps running on a substitute pressure.
Possible causes
- Loose or corroded terminals in the sensor C connector high
- Chafed wiring with intermittent contact medium
- Interference from ignition or actuator wiring routed nearby low
- Sensor C with an unstable internal element low
Symptoms
- MIL on, possibly coming and going
- Occasional brief hesitation or uneven boost
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P227E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.