OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P227D

Barometric Pressure Sensor C Circuit High

P227D is the high-voltage counterpart of P227C. On GM's 2018 diesel the sensor C input has a pull-up, so both a short to the supply and a broken signal wire push it above 90.2 % of 5 V (about 115.4 kPa); after 320 failures in 400 samples it is a Type B fault. The supercharged LT4 uses 90 % (115 kPa) and attributes the code only to a short to power, here as Type A with the MIL on the first trip, because its input reads an open line as low. GM's 2023-2024 twin-throttle engine flags a reading above 115 kPa held for 2 s over two trips. Since the atmosphere cannot produce such a value at the sensor positions concerned, the ECM switches to a substitute, and corrections for altitude or boost become less exact.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 7D

Possible causes

  • Signal wire of sensor C shorted to 5 V or battery voltage high
  • Broken signal wire or sensor ground on inputs with pull-up medium
  • Sensor C internally defective low

Symptoms

  • MIL on
  • Little change in driving; possibly reduced boost or poorer altitude compensation

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P227D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication