OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P227C

Barometric Pressure Sensor C Circuit Low

P227C flags a voltage from pressure sensor C that is too low. GM's 2018 tables show two variants. On the diesel, where sensor C measures turbocharger inlet pressure and the input has a pull-up, only a short to ground pulls it below 39.4 % of 5 V (about 50.2 kPa); 320 failures in 400 samples make it a Type B fault. On the supercharged 6.2 L LT4 the limit is 40 % (50.9 kPa), and both a grounded and an open line count, as Type A with the MIL on the first trip. GM's 2023-2024 twin-throttle engine looks at the pressure value: below 50 kPa for 2 s, two trips. GM bulletin 22-NA-188 (1.3 L L3T and 2.0 L LSY turbo) links P227C after an ECM replacement to a redesigned MAF sensor that requires the matching calibration. P227D is the high counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 7C

Possible causes

  • Signal wire of sensor C shorted to ground high
  • Open signal or 5 V supply line on inputs that read an open circuit as low medium
  • Replacement control module without the calibration that matches the fitted sensor low
  • Sensor C internally defective low

Symptoms

  • MIL on, on some engines immediately
  • Engine runs on a substitute value, at most slightly less power

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P227C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication