OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2276

O2 Sensor Signal Biased/Stuck Lean (Bank 2, Sensor 3)

P2276 needs three oxygen sensors on bank 2, so it only occurs on V or flat engines whose second bank carries a front, a mid-catalyst and a post-catalyst sensor. It reports that the post-catalyst sensor of bank 2 does not reach a rich reading. No manufacturer publishes a threshold for this exact code; Jaguar Land Rover lists it, with P2277 and the heater and circuit codes of that sensor, for the 2014 to 2016 3.0 supercharged V6 in the LR4, Range Rover and Range Rover Sport, where water on the hot element cracked the sensor. Ford's monitor runs the same switch-point test on sensors 2 and 3 and fails a rich peak below 0.42 V. CARB requires secondary sensors to be checked for sufficient output. If bank 1 is fault-free, compare both third sensors and look for an exhaust leak on bank 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 76

Possible causes

  • Bank 2 third oxygen sensor aged or cracked by water high
  • Exhaust leak on bank 2 ahead of sensor 3 medium
  • Damaged wiring or connector of sensor 3 low

Symptoms

  • Malfunction indicator lamp on
  • No noticeable change in driveability

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2276

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication