OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2270

O2 Sensor Signal Biased/Stuck Lean (Bank 1, Sensor 2)

P2270 concerns the oxygen sensor behind the catalyst on bank 1. When the mixture turns rich, this sensor should rise to a high voltage; if it stays low, the ECM treats it as biased or stuck lean and can no longer rely on it for catalyst monitoring or the post-catalyst trim. GM's 2018 four-cylinders add fuel during a coast-down and set the code if the signal is still under 760 mV once 55 g of air have passed (Type B, two trips); Ford fails a sensor whose highest voltage stays under 0.42 V. P2096 reports the trim correction, P0136 a sensor without activity. Documented triggers include oil on the sensor (Honda Pilot 2023 to 2025), an oil-soaked connector (Mazda CX-9), a bent terminal (GM 2013 trucks) and ECM software (Subaru WRX 2015 to 2016, Forester turbo).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 70

Possible causes

  • Rear oxygen sensor aged, contaminated or slow to reach rich voltage high
  • Exhaust leak ahead of the rear sensor diluting the gas with air medium
  • Oil in the sensor connector or a bent terminal medium
  • Calibration issue fixed by an ECM update low

Symptoms

  • Malfunction indicator lamp on
  • Catalyst and oxygen sensor readiness not completing
  • Usually no noticeable change in driveability

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2270

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication