OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P226E

Particulate Filter Deteriorated/Missing Substrate (Bank 2)

P226E reports a damaged or missing particulate filter core on bank 2, which only exists where each cylinder bank has its own filter. Ford documents it in its 2024-2025 OBD summary for petrol engines: the gasoline particulate filter check runs once the filter has been above 250 °C for 30 s and exhaust flow lies between 300 and 850 m³/h; if the lowest measured back pressure stays below the missing-brick threshold, a ratio under 1.0, for 5 s, P226E is stored for bank 2 and P226D for bank 1, with Mode 6 results under monitor ID $B3. No public bulletin covers P226E. CARB's missing-substrate rule for diesels follows the same idea. A pressure line problem can mimic a missing core, so check lines and sensor before condemning the filter.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 6E

Possible causes

  • Bank 2 filter core cracked, melted or removed high
  • Pressure sensing line of bank 2 loose, cracked or blocked medium
  • Back pressure sensor reading too low low

Symptoms

  • MIL on
  • Usually no noticeable change in driving behaviour

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P226E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication