P226A
Water in Fuel Lamp Control Circuit
P226A concerns the output that switches the water-in-fuel warning lamp, not the sensor. The control unit drives the lamp circuit and checks it electrically; an open lamp, a broken wire or a shorted driver lets it set this code. No manufacturer documents P226A publicly, and on current vehicles the cluster usually receives the warning as a bus message, so a discrete lamp line that could fail is found mainly on older or commercial diesels. The practical risk is that the driver is no longer warned when the separator fills, while the sensor itself keeps working and P2269 can still be stored. CARB treats the warning lamp as part of the driver information, not as an emission input, so this code normally does not turn on the MIL. Check bulb, socket, wiring and driver output.
Possible causes
- Burnt-out warning lamp or corroded lamp socket high
- Open or shorted wire between control unit and lamp medium
- Faulty lamp driver in the control unit low
Symptoms
- Water-in-fuel lamp does not light during the bulb check at ignition on
- Lamp stays on permanently regardless of the filter state
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P226A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.