P2266
Water in Fuel Sensor A Circuit Low
P2266 is set when the signal line of water-in-fuel sensor A stays below its valid range, typical of a grounded signal wire or of a conductive path that should not be there. Ford documents the code on 2017 and 2018 Super Duty trucks with the 6.7L diesel built up to 15 March 2018: bulletin 18-2133 links P2266, P2269 and P1140 with a lit water-in-fuel lamp to water entering connector C3080 at the sensor, which sits between tank and frame rail. The procedure checks the sensor across pins 1 and 2 for 795 to 815 kOhm, replaces it if out of range, then dries and wraps the connector. As water itself conducts, a wet plug can fake both a low circuit and a water alarm. P2267 is the high side, P2264 the general circuit code.
Possible causes
- Water intrusion into the sensor connector bridging signal and ground high
- Sensor with internal resistance outside specification medium
- Signal wire chafed against the frame and shorted to ground medium
Symptoms
- Water-in-fuel lamp on although no water is in the separator
- Often stored together with P2269
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2266
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.