P2264
Water in Fuel Sensor A Circuit
P2264 is the general circuit code for water-in-fuel sensor A, the probe in the diesel filter or separator that detects water by its conductivity. GM's 2018 diesel tables explain a neat self-test: after the ignition has been off for more than about 8 h, a healthy sensor briefly signals water during the first 0.3 to 1.8 s after power-up. If that pulse is missing in 10 of 14 samples of 100 ms, P2264 sets as a Type C code that turns on the Service Vehicle Soon lamp rather than the MIL; versions exist for sensors wired to the ECM and to the fuel tank zone module. Ford's 2014 PCM table also lists the code. With the circuit faulty, the warning for real water no longer works, so the separator should be drained by hand until it is fixed. P2265 to P2268 split the fault further.
Possible causes
- Water-in-fuel sensor that no longer performs its power-up self-test high
- Corroded or loose connector at the filter housing, exposed to road spray high
- Open or damaged wire between sensor and ECM or tank zone module medium
- Incompatible sensor fitted during a filter change low
Symptoms
- Service lamp or message on, engine runs normally
- No warning if water actually collects in the separator
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2264
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.