OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2260

AIR System Control B Circuit High

P2260 flags secondary air control circuit B sitting at too high a level, as with a short to the supply or a driver output that cannot switch. Circuit B drives the second pump, second relay or a separate air valve, depending on the engine. Where the ECM grounds the relay to switch it, a short to power means the relay can never pull in: pump or valve B stays idle, and the catalyst on that side heats up more slowly after a cold start. No manufacturer documents its threshold for circuit B; GM only lists P2260 among the codes in its connector bulletin PIP5094 (2014 and older). For circuit A, GM's 2018 tables treat 0.5 ohm or less between signal and supply, with the driver on, as a Type B fault, which shows the type of check involved. P2259 is the low-level counterpart, P2258 the same fault on circuit A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 60

Possible causes

  • Control wire of circuit B shorted to a battery-voltage feed high
  • Relay or air valve B with an open coil, depending on how the driver is diagnosed medium
  • Output stage for circuit B in the engine control module defective low

Symptoms

  • MIL on
  • Second secondary air pump or valve does not operate after a cold start
  • Increased cold-start emissions, possibly with a secondary air flow code on one bank

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2260

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication