P225F
NOx Sensor Performance - Signal Biased/Stuck Low (Bank 1 Sensor 2)
P225F is set when the downstream NOx sensor of bank 1 reports less NOx than expected or does not move away from a low value. A sensor behind the SCR catalyst that reads too low makes the catalyst look better than it is, so the efficiency monitor can no longer be trusted. The only public manufacturer source is the Volvo and Mack NOx sensor replacement guide for US10 and newer trucks: it lists P225F next to P225D among codes whose description mentions the NOx sensor although the sensor is rarely the cause, notes that the probe is reading fresh air, and tells technicians not to replace it. Leaks in the exhaust ahead of the sensor and harness faults are the more likely culprits. P225D is the upstream case; P225E the high-reading counterpart.
Possible causes
- Exhaust leak upstream of the downstream sensor drawing in outside air high
- Chafed or corroded wiring between sensor module and probe medium
- Downstream NOx sensor with reduced sensitivity low
Symptoms
- MIL on
- SCR efficiency cannot be confirmed, readiness may stay open
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P225F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.