P225E
NOx Sensor Performance - Signal Biased/Stuck High (Bank 1 Sensor 2)
P225E points at the downstream NOx sensor of bank 1, behind the SCR catalyst, reading persistently high. Because that sensor sees what is left after urea dosing, a high value can be a sensor offset or genuine NOx slipping through a weak catalyst, poor DEF or a faulty dosing valve. Volvo and Mack therefore put P225E in the group where either sensor or the aftertreatment itself may be the cause: their replacement guide and bulletin KC-107 require a NOx conversion test or the aftertreatment analysis in PTT before any part is changed, and for P225E they also send technicians to the DEF dosing valve diagnosis. No public bulletin from a passenger car maker covers P225E. P225C is the same fault upstream; P225F is the low-reading downstream case.
Possible causes
- Real NOx slip from a weak SCR catalyst, poor DEF quality or a faulty dosing valve high
- Downstream NOx sensor with a positive offset medium
- Control software that evaluates the sensor incorrectly low
Symptoms
- MIL on, often together with P20EE
- Increased DEF consumption or DEF quality warnings
- Power reduction possible if SCR efficiency codes follow
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P225E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.