OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P225C

NOx Sensor Performance - Signal Biased/Stuck High (Bank 1 Sensor 1)

P225C says the upstream NOx sensor of bank 1 reports more NOx than is plausible. Volvo describes its test on US17+OBD19 trucks: during engine motoring with zero fuel the engine makes no NOx, so the inlet sensor must fall below 50 ppm within about 10 s; each failure lights the MIL, which needs three clean drive cycles to go out. Volvo admitted false settings and told dealers not to replace the sensor. Mack and Volvo (KC-107) demand a NOx conversion test first; inlet and outlet should agree within 40 ppm before shutdown. Isuzu cured P225C on 2021 F-Series 5.2L trucks with a DCU update. FCA found most returned sensors from 3.0 EcoDiesel Ram and Jeep models fault-free and points to intake or EGR leaks, soot-clogged sensor ports and skewed MAF or coolant readings.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 5C

Possible causes

  • Engine or DEF control unit software that flags the sensor too eagerly high
  • Leak in the charge air path or an EGR valve stuck partly open medium
  • Air mass or coolant temperature signal that skews the NOx model medium
  • Upstream NOx sensor with a genuine positive offset low

Symptoms

  • MIL on, often without any noticeable driving fault
  • Code returns after the NOx sensor has been replaced
  • Higher DEF consumption or SCR efficiency codes in some cases

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P225C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication