OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P225A

NOx Sensor Calibration Memory (Bank 1 Sensor 1)

P225A concerns the front NOx sensor of bank 1, the one ahead of the SCR catalyst. Modern NOx probes come with their own control unit that holds a sensor-specific calibration and reports finished values over CAN; this code means the stored calibration data of that unit cannot be read or fails its check. Ford's 2014 PCM code table carries P225A as a MIL code, but no manufacturer publishes the test or a threshold. Ford's 2023 diesels report memory errors inside the NOx sensor module under P2200 instead. CARB requires NOx sensor faults to be caught when the sensor can no longer serve as a feedback or monitoring input. P225B is the same fault on the downstream sensor. Usually the sensor assembly is replaced, as its memory cannot be repaired.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 5A

Possible causes

  • Internal memory or checksum fault in the NOx sensor control unit high
  • Replacement sensor with a part number or calibration that does not suit the vehicle medium
  • Supply voltage dropout or poor connector contact while the module was storing data low
  • Engine or aftertreatment control unit software that misreads the sensor data low

Symptoms

  • MIL on, usually without any change in how the engine runs
  • SCR dosing runs without valid feedback, so NOx emissions may rise
  • Follow-up NOx catalyst efficiency codes possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P225A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication