OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2258

AIR System Control A Circuit High

P2258 reports that the line controlling secondary air (AIR) pump A or its relay sits at too high a level, usually because it is shorted to battery voltage or the driver cannot pull it down. The pump only runs briefly after a cold start to heat the catalyst faster, so the fault mainly raises warm-up emissions. GM's 2018 tables (LWE section) check it while the low-side driver is switched on: 0.5 ohm or less between signal and supply, in 20 of 25 samples of 250 ms, Type B with the MIL after two trips. VW's 2014 book for the Touareg 3.0 TSI (CGFA) gives a signal current of 0.60 to 2.40 A as criterion. Ford names P2258 beside P0412 as a secondary air fault that disables its catalyst temperature model. P2257 is the low counterpart; P2259/P2260 belong to circuit B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 58

Possible causes

  • Control wire of the AIR pump relay chafed through and touching a battery-voltage feed high
  • Secondary air relay with shorted coil or welded contacts medium
  • Moisture or corrosion in the relay or pump connector bridging terminals medium
  • Faulty output stage in the engine control module low

Symptoms

  • MIL on, often without any noticeable change in driving
  • Secondary air pump silent after a cold start
  • Higher hydrocarbon emissions during warm-up, possibly a failed emissions test

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2258

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication