OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2254

O2 Sensor Negative Current Control Circuit/Open (Bank 2 Sensor 1)

P2254 concerns the negative current control line - also called reference ground, virtual ground or COM - of the wide-band air-fuel sensor ahead of the catalyst on bank 2. Ford's OBD summaries (2012 and 2020-2023) set it for an open line: with Bosch sensors the PCM briefly injects a reference current and flags the line if lambda barely moves, within about 10 s; with NTK sensors the interface chip reports the open line directly. VW's 2014 Passat and CC books set it when the front signal sits at 1.47-1.52 V while the cell resistance exceeds 950 ohms. P2251 is the same fault on bank 1, P2255/P2256 are low/high faults. Closed-loop mixture control on bank 2 is lost.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 54

Possible causes

  • Broken reference ground wire or pushed-out pin between sensor and ECM high
  • Internal open circuit in the wide-band sensor medium
  • Corroded sensor connector with high contact resistance low

Symptoms

  • Check engine light
  • Higher fuel consumption from open-loop fuelling on bank 2
  • Possible rough running or failed emissions test

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2254

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication