OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2250

O2 Sensor Reference Voltage Circuit High (Bank 2 Sensor 1)

P2250 signals that the reference voltage line of the upstream wide-band sensor on bank 2 is too high, as happens with a short to the heater feed or battery voltage, or a breakdown inside the ceramic. No manufacturer documents P2250 publicly, and no bulletin in the NHTSA index names it. Ford sends any wide-band wire shorted to supply voltage to P0152 and uses P2247 only for the open line, so Ford engines never store it. Because Bosch allows the Nernst cell only a 250 microamp load, an outside voltage on this lead can ruin a replacement sensor unless the wiring is repaired first. CARB requires fuel-control sensors to be monitored for circuit faults, with distinct codes where practical. P2246 is the bank 1 counterpart, P2249 the low fault, P2247 the open circuit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 50

Possible causes

  • Reference voltage wire of the bank 2 sensor shorted to heater supply or battery voltage high
  • Internal short between heater and Nernst cell medium
  • Fault in the sensor interface of the ECM low

Symptoms

  • Check engine light
  • Higher fuel consumption
  • Repeat failure of a new sensor if the wiring short remains

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2250

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication