P224F
Alternative Fuel Tank Shutoff Valve A Control Circuit High
P224F reports a control circuit of tank shutoff valve A that reads too high, typically a wire touching battery voltage. In TransEco Energy's AFCM fault list the cause is given as shorted to power, the MIL is lit and the gas system keeps working under the failure mode strategy. That matters because a valve held open by an external voltage can no longer be closed by the control unit: Ford's 2003 bi-fuel CNG system relies on closing the tank valve when gas pressure falls below 517 kPa, and GM's bi-fuel Impala keeps its cut-off solenoids energized only while the engine turns. Ford's Boss 302S list carries P224F too, though mislabelled as Low. P224E is the low side; CARB requires both directions to be monitored.
Possible causes
- Control wire of the tank valve shorted to battery voltage high
- Output stage in the alternative fuel control module stuck on medium
- Wiring mistake after a conversion or repair low
Symptoms
- Check engine light
- Tank valve may stay open after switching off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P224F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- transecoenergy.com/Installer-Portal-Info/DTC-Info/DTC List.pdf
- static.nhtsa.gov/odi/inv/2008/INRD-PE08063-33504P.pdf
- static.nhtsa.gov/odi/tsbs/2014/MC-10114282-9999.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2
- performanceparts.ford.com/download/boss302spdfs/2014/2014 BOSS 302S OBDII Codes.pdf