P2246
O2 Sensor Reference Voltage Circuit High (Bank 1 Sensor 1)
P2246 means the reference voltage line of the bank 1 front wide-band sensor reads too high, typically from a short to battery or heater voltage or a short inside the sensor. No manufacturer publishes a threshold for P2246. GM's 2018 Duramax table 18OBDG04 names it, together with P2245, P2252 and P2253, as a fault that makes the front sensor signal unusable, but gives no setting criteria. Ford logs any wide-band lead that is shorted to supply voltage as P0132 and keeps P2243 for the open line, so Ford vehicles do not use this code. Bosch limits the Nernst cell to a 250 microamp load, which is why an external voltage on this wire can damage the sensor or the interface. CARB requires circuit faults of fuel-control sensors to be detected. P2245 is the low fault, P2250 bank 2.
Possible causes
- Reference voltage wire shorted to heater supply or battery voltage high
- Internal short between heater and Nernst cell in the sensor medium
- Fault in the sensor interface of the ECM low
Symptoms
- Check engine light
- Higher fuel consumption
- Repeat failure of a new sensor if the wiring short remains
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2246
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.