OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2242

O2 Sensor Positive Current Control Circuit High (Bank 2 Sensor 1)

P2242 flags the pump-current circuit of the bank 2 front wide-band sensor as too high, usually a short to the heater feed or battery voltage, or a signal locked at its midpoint although the mixture is being changed. No manufacturer publicly documents P2242 with thresholds. Saab describes the bank 1 version P2239 for its 2.0 turbo: 1.48-1.51 V held for 1 s while closed loop enriches the mixture. Ford's 2020-2023 summary routes any short to battery on a wide-band sensor wire to P0152 instead. CARB requires fuel-control sensors to be checked for wiring faults and implausible readings. P2240 is the open circuit, P2241 the low fault, P2239 the same fault on bank 1. Since a voltage short can kill a replacement sensor, the bank 2 harness should be checked first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 42

Possible causes

  • Bank 2 pump-current wire shorted to heater supply or battery voltage high
  • Internal short in the bank 2 wide-band sensor medium
  • Damaged sensor interface in the ECM low

Symptoms

  • Check engine light
  • Bank 2 lambda value stuck near 1.0
  • Replacement sensor fails again if the short remains

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2242

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication