P2241
O2 Sensor Positive Current Control Circuit Low (Bank 2 Sensor 1)
P2241 reports the pump-current circuit of the bank 2 front wide-band sensor at too low a level, typically a grounded wire or a sensor that cannot pump enough oxygen. No manufacturer publicly documents P2241 with thresholds. The bank 1 twin P2238 is described by Saab for its 2.0 turbo, where the signal must climb past 1.7 V on overrun with the injectors off; a V engine would run the same logic per bank. Ford instead files a grounded pump-current wire under P0151 and keeps P2240 for the open line. CARB demands that fuel-control sensors be checked for broken or shorted circuits and for implausible readings, with separate codes where practical. P2240 is the open circuit, P2242 the high-side fault on bank 2. Bank 2 fuelling falls back to open-loop values.
Possible causes
- Bank 2 pump-current wire shorted to ground high
- Aged bank 2 front sensor with weak pump cell medium
- Fault in the ECM sensor interface for bank 2 low
Symptoms
- Check engine light
- Higher fuel consumption from open-loop fuelling on bank 2
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2241
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.