OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2240

O2 Sensor Positive Current Control Circuit/Open (Bank 2 Sensor 1)

P2240 is the open pump-current circuit of the front wide-band sensor on bank 2, so it only exists on V engines and boxers. Ford's summaries (2012 and 2020-2023) introduced it to replace P0154; detection works as on bank 1, by lambda failing to react to reference-current pulses or by the NTK interface chip. VW's 2014 Touareg and CC books flag 1.49-1.51 V combined with a lambda controller offset above 0.07 or a controller at its limit. GM's 2005 V6 adds a fuel cut-off test (signal below 1.7 V for 2 s). FCA reflashes the PCM for P2240 on the 2025 Ram 1500 and Wagoneer with the 3.0 Hurricane (bulletins 18-071-26, 18-082/083-26), and Jaguar Land Rover lists it among the 3.0 V6 sensor faults caused by water shock.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 40

Possible causes

  • Open pump-current wire or loose pin at the bank 2 sensor connector high
  • Bank 2 front sensor damaged by water or thermal shock medium
  • PCM calibration that sets the code without a hardware fault (FCA 2025 Hurricane) low

Symptoms

  • Check engine light
  • Bank 2 lambda value stuck at 1.0 in live data
  • Higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2240

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication