OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P223F

O2 Sensor Reference Resistance Out Of Range (Bank 2)

P223F is the reference-cell resistance check for the front wide-band sensor of bank 2. GM's 2016 and 2018 tables translate the measured resistance into element temperature and count readings below 700 °C or above 1,000 °C; 64 of 80 samples (2018) or 128 of 160 (2016) at 25 ms set a Type B code. The monitor waits for heater warm-up plus 20 s and is blocked while the bank 2 heater codes P0050-P0052 or P0155 are present, so a pure heater fault shows up there first. A reading that is too cold despite a working heater points to a sensor whose ceramic has aged and become high-resistance; too hot suggests overheating, for example from misfire. Bosch's LSU 4.9 data sheet gives 300 ohms as the nominal cell resistance. P223E is bank 1, P223D the pump-current check of the same sensor.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 3F

Possible causes

  • Bank 2 sensor ceramic aged and high-resistance high
  • Weak heater supply or high resistance in the heater wiring medium
  • Sensor overheated by misfire or very high exhaust temperature low

Symptoms

  • Check engine light after two drives
  • Bank 2 lambda control slow to become active after a cold start

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P223F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication