OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P223E

O2 Sensor Reference Resistance Out Of Range (Bank 1)

P223E checks the internal resistance of the reference (Nernst) cell in the bank 1 wide-band sensor. That resistance falls as the ceramic heats up, so the ECM uses it as a thermometer; Bosch specifies 300 ohms nominal for the LSU 4.9 at operating temperature. GM's tables (2016-2019) convert the value supplied by the interface chip into an element temperature and flag anything below 700 °C or above 1,000 °C in 80 % of samples (64 of 80 in 2018, 128 of 160 in 2016/2019), starting 20 s after heater warm-up; the code is Type B. GM bulletin 16-NA-266 covers 2016-2017 ATS, CTS, CT6, Camaro, Malibu and Envision with the 2.0 turbo LTG: a voltage spike inside the ECM sets P223E or P0132 and also blocks remote start, cured by reprogramming. P223F is bank 2, P0135 the heater itself.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 3E

Possible causes

  • Aged sensor whose reference cell resistance has drifted high
  • Heater not holding the element at temperature (heater, wiring or control) medium
  • ECM calibration fault on GM 2.0 turbo LTG (bulletin 16-NA-266) medium

Symptoms

  • Check engine light after two consecutive drives
  • Remote start refuses to start the engine (GM LTG models)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P223E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication