P223D
O2 Sensor Pumping Current Range/Performance (Bank 2)
P223D applies the pump-current plausibility test to the front wide-band sensor of bank 2 on V engines. GM's 2016 and 2018 tables describe it for engines with a Continental interface chip: during a fuel cut-off window between 5 s and 12 s, a reading above 5.0 mA, within ±0.3 mA of zero, or below -0.10 mA is counted, and 40 hits in 160 samples in any window set the code as Type B. The test is skipped while bank 2 heater faults (P0050-P0052) or P0155 are active, because a cold element pumps poorly. The Bosch LSU 4.9 data sheet shows why the check works: pump current is zero at lambda 1, negative when rich and positive when lean, so air must give a clear positive value. P223C is the bank 1 version; P2240, P2247 and P2254 isolate open wires.
Possible causes
- Worn bank 2 wide-band sensor that no longer pumps correctly in air high
- Interrupted pump-current or reference circuit of the bank 2 sensor medium
- Sensor heater too weak to keep the element at temperature low
Symptoms
- Check engine light after two drives
- Often no driveability complaint
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P223D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.