P223A
Reductant Heater E Control Circuit
P223A covers the control circuit of a fifth DEF heating element, heater E. Unlike heaters A to D, which each have four codes for open, performance, low and high, heater E gets only this one code, so any electrical fault of its driver or wiring ends up here. No maker documents P223A publicly. As a reference, GM's 2025 Duramax tables check comparable heater outputs by watching the low-side driver voltage and load current: a fault seen while heating forces the output off so the exact failure can be pinpointed, and heater circuits there are Type A. Which element carries the letter E depends on the system; most published SCR designs stop at three or four heaters. In frost an unheated section may stay frozen, so dosing and SCR monitoring suffer.
Possible causes
- Open or shorted wiring or connector of heater E high
- Heating element E burnt out or shorted medium
- Faulty output stage in the controlling module low
Symptoms
- Check engine light and SCR warning
- DEF dosing delayed or blocked in freezing weather
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P223A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.