OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2236

O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank 2 Sensor 3)

P2236 would be set if the heater of the third oxygen sensor on bank 2 leaked into its signal wire. Such a sensor sits furthest downstream and exists only on engines with two catalyst stages per bank. No manufacturer documents this code publicly, and Jaguar Land Rover's 2015 list for its V6 with sensors 3 on both banks does not use it either. The mechanism matches P2232/P2235: the heater is pulsed with battery voltage while the sensor signal stays below about 1 V, so any coupling shows up as a voltage step when the heater switches; GM uses more than 2 V within 0.04 s. CARB requires every monitored oxygen sensor circuit to be checked. P2233 is bank 1. Driving is unaffected; the lamp and a failed inspection are the consequences.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 36

Possible causes

  • Internal leakage between heater and sensing element of sensor 3 on bank 2 high
  • Long underbody wiring to the rear sensor chafed or heat-damaged medium
  • Road salt corrosion in the sensor connector low

Symptoms

  • Check engine light with normal driving behaviour
  • Readiness for catalyst or oxygen sensor monitor not set

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2236

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication