P2235
O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank 2 Sensor 2)
P2235 concerns the post-catalyst oxygen sensor on bank 2, found on V engines with a catalyst per bank. The ECM sets it when switching off the heater makes the sensor voltage spike. GM runs the check only once the sensor is past its dew-point phase and the modelled exhaust has been above 250 °C for 90 s (and below 800 °C); the failure threshold, as for P2232, is a jump above 2 V within 0.04 s in more than 4 of 6 switch-offs. It appears in the 2005 2.8/3.6 V6 tables, the 2008 3.6 LLT tables and the 2024 set 24OBDG07, each with the MIL after two trips. Because the fault is tied to one sensor position, swapping banks is a quick plausibility check before parts are ordered. P2232 is bank 1, P2234 the front sensor of bank 2.
Possible causes
- Internal leakage between heater and sensing element of the bank 2 rear sensor high
- Sensor wires damaged by heat or chafing near the bank 2 catalyst medium
- Water ingress in the rear sensor connector low
Symptoms
- Check engine light after two drives
- Bank 2 catalyst monitor not completed
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2235
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.