OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2234

O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank 2 Sensor 1)

P2234 means the heater of the front air-fuel sensor on bank 2 couples into its measuring circuit. On a wide-band sensor the disturbance is small, so the check is finer than on rear sensors. GM's 2005 tables for the Bosch-equipped 2.8/3.6 V6 look for a signal step of 0.08-0.2 V appearing no later than 0.05 s after each heater switching edge; 18 such steps in a 10 s window count as a failure, the sensor must have been fully hot for 10 s, and the MIL follows after two trips. Jaguar Land Rover lists P2234 among the bank 2 front-sensor codes of the 2014-2016 LR4, Range Rover and Range Rover Sport 3.0 V6 and blames thermal shock from water hitting the hot element; the sensor is replaced. P2231 is the same fault on bank 1. Closed-loop fuelling on bank 2 may drop out.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 34

Possible causes

  • Front sensor element cracked by thermal shock (water on the hot sensor) high
  • Heater and signal wires of the bank 2 sensor touching in the harness medium
  • Moisture in the sensor connector bridging heater and signal pins low

Symptoms

  • Check engine light
  • Higher fuel consumption when bank 2 runs without lambda control
  • Other bank 2 front-sensor codes stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2234

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication