OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2233

O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank 1 Sensor 3)

P2233 is the heater-to-signal short for sensor 3 on bank 1, a third oxygen sensor that some engines fit after a second catalyst or between two catalyst bricks. No manufacturer documents this code publicly. GM's checks for the rear-sensor codes P2232/P2235 show how such a fault is normally caught: the signal leaps by more than 2 V within 0.04 s whenever the heater is switched off. Jaguar Land Rover's 2015 bulletin for the 3.0 supercharged V6, which carries three sensors per bank, lists many sensor 3 faults but none of this type. CARB requires circuit faults of every monitored oxygen sensor to be detected. P2236 is the bank 2 counterpart. A third sensor serves only monitoring, so the car drives normally with the warning lamp on.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 33

Possible causes

  • Internal leakage between heater and sensing element of sensor 3 high
  • Sensor 3 wiring melted or chafed along the exhaust or underbody medium
  • Corroded underbody connector of the third sensor low

Symptoms

  • Check engine light without noticeable driving change
  • Emissions inspection failed because of the stored code

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2233

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication