P2232
O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank 1 Sensor 2)
P2232 reports that the heater supply of the oxygen sensor behind the catalyst on bank 1 is bleeding into that sensor's signal line. A switching sensor only produces up to about 1 V, so the ECM watches its signal at the instant the heater is switched off. GM's tables for the 2005 2.8/3.6 V6, the 2008 3.6 LLT and the 2024 set 24OBDG07 flag a jump of more than 2 V within 0.04 s of heater turn-off in more than 4 out of 6 events, with the MIL after two trips. The Saab 9-5 (2010, 2.0 turbo) checks whether signal and heater voltage rise and fall together and treats the fault as Type B. P2231 is the front sensor, P2235 the rear position on bank 2. Mixture control continues, but catalyst monitoring loses its rear signal.
Possible causes
- Internal leakage between heater and sensing element of the rear oxygen sensor high
- Signal and heater wires fused or chafed together near the exhaust medium
- Water or corrosion bridging pins in the sensor connector low
Symptoms
- Check engine light after two drives
- Catalyst monitor not completed or catalyst code stored alongside
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2232
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2005/2005file14.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2008/08 GRP02 LLT Engine.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2024/24OBDG07.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p0137-p0138-p0140-p2232-p2270-or-p2271-ldk-with-turbocharger
- law.cornell.edu/regulations/california/13-CCR-1968.2