P2228
Barometric Pressure Sensor A Circuit Low
P2228 sets when the voltage from barometric pressure sensor A stays below the lowest value a real atmosphere could produce. Ford's gasoline summaries (2012 and 2020-2023) use under 2.0 V, which would mean an altitude above 15,000 ft, for 5 s; on these engines the sensor is mounted on the PCM circuit board. Ford's 2023 diesels flag under 0.25 V (about 6 kPa) after 0.5 s. GM's 2018 diesel tables attribute it to a grounded or broken signal line on a pull-down input: below 35.5 % of the 5 V supply (equal to 50 kPa) in 320 of 400 readings, Type B with the MIL after two trips. In Ford's 2024 software the same fault appears as P2226-16. P2229 is the high counterpart. The engine runs on a substitute pressure, so drivers mostly see only the lamp.
Possible causes
- Signal wire of an external BARO sensor shorted to ground or open medium
- Defective sensor inside the PCM (Ford, Mazda and others), PCM replacement medium
- Low or missing 5 V reference to the sensor low
Symptoms
- Check engine light
- Auto start-stop deactivated
- Scan tool shows an implausibly low barometric pressure
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2228
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.