P2222
NOx Sensor Heater Sense Circuit Range/Performance (Bank 2)
With P2222 the heater feedback of the bank 2 NOx sensor is electrically present, yet what it reports does not match the heating command: the cell warms too slowly or settles at the wrong resistance. No manufacturer documents this bank 2 code. Two bank 1 descriptions show the approach. GM's 3.0L LZ0 (P2209) compares raw heater resistance with its target and fails a deviation over 3 percent in 50 of 100 samples, only after 45 s of good supply and 180 s past the dew point, Type B. Ford's diesel summary uses the matching rear sensor code P220F for heater current below 0.4 A or a duty cycle more than 20 percent off. An aged heater or weak supply is typical. P2221 is the general sense fault.
Possible causes
- Aged heater in the bank 2 NOx probe with drifted resistance high
- Low supply voltage or poor ground at the sensor module medium
- Heater wiring with added resistance low
Symptoms
- Malfunction indicator lamp on
- Bank 2 NOx sensor slow to become ready after a cold start
- SCR monitor for bank 2 delayed
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2222
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.