OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2220

NOx Sensor Heater Control Circuit High (Bank 2)

P2220 is the high-side counterpart of P2219: on the bank 2 NOx sensor, the heater control line carries battery voltage when the heater should be off or regulated, so the element may overheat or the output stage cannot switch. A pinched lead touching a feed wire or a failed driver inside the sensor are the usual causes. The bank 2 code is not documented by any manufacturer. GM's 3.0L LZ0 describes the bank 1 version P2207 as a short to battery at the heater control pin, judged on 80 of 160 samples with over 11 V on the powertrain relay and confirmed as Type B after two trips. P2218 is the open circuit and P2224 a high signal on the heater sense side. Until repaired, SCR control for bank 2 runs without NOx feedback.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 20

Possible causes

  • Heater control lead shorted to a supply wire high
  • Failed heater driver inside the bank 2 sensor module medium
  • Heat-damaged connector with pins bridged low

Symptoms

  • Malfunction indicator lamp on after two trips
  • Bank 2 NOx reading missing or invalid

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2220

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication