P2218
NOx Sensor Heater Control Circuit/Open (Bank 2)
A NOx sensor cannot measure until its built-in heater has taken the ceramic cell to several hundred degrees, and the sensor electronics switches that heater itself. P2218 reports a break in the heater control path of the bank 2 sensor, either inside the probe or in the lead to the sensor module. No manufacturer documents the bank 2 version. The bank 1 code P2205 is well described: GM's 6.6L LML sets it when an open heater is reported longer than 10 s with the battery at 11 V or more, the 3.0L LZ0 on an open load at the heater control pin, both Type A with the MIL after one trip. Without heating, the bank 2 sensor never becomes ready. P2219 and P2220 are the shorted cases, P2221 the heater sense side.
Possible causes
- Heater element in the bank 2 NOx probe burnt through high
- Broken conductor between probe and sensor module medium
- Pushed-back or corroded pin in the sensor connector low
Symptoms
- Malfunction indicator lamp on after one trip
- Bank 2 NOx sensor never reports ready
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2218
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.