OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P220A

NOx Sensor Supply Voltage Circuit (Bank 1 Sensor 1)

A smart NOx sensor draws its own operating power, mostly for the probe heater. P220A means the supply reaching the upstream sensor on bank 1 is outside its window. Ford's 6.7L and 3.0L diesels flag above 16.5 V or below 8.5 V; GM's 3.0L Duramax (LZ0) flags below 9.9 V while the engine runs, Type B after two trips. On the 6.6L LML, GM feeds the sensor from a DC/DC booster in the glow plug module and sets P220A when that module reports its output shorted or overloaded (Type B). VW's 2014 Touareg TDI uses a 1.5 V deviation. Volvo and Mack advise checking supply wiring, fuses and relays rather than the sensor. P220B is the downstream sensor, P220C/P220D bank 2. The sensor stays inactive.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / 0A

Possible causes

  • Blown fuse, faulty relay or poor ground in the sensor supply high
  • Supply wire chafed, corroded or with high resistance medium
  • Supply booster in the glow plug control module (GM 6.6L LML) medium
  • Weak battery or charging-system voltage out of range low

Symptoms

  • Malfunction indicator lamp on
  • Upstream NOx sensor shows no value or no communication
  • Other NOx sensor codes stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P220A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication