P2204
NOx Sensor Circuit Intermittent (Bank 1 Sensor 1)
P2204 describes an upstream NOx sensor on bank 1 whose signal path works most of the time but keeps dropping out. Smart NOx sensors report the state of their measuring circuit (open wire, short or no error) to the engine computer over CAN; when such fault messages come and go faster than a steady circuit fault would allow, this code fits. No manufacturer publicly documents thresholds for P2204, so the logic is calibration-specific; CARB generally requires continuous detection of circuit-continuity faults on NOx sensors. Look for loose pins, heat-damaged cable near the exhaust and water in the connector. P2200 is the steady circuit fault, P2202/P2203 a value out of range. Expect a MIL and SCR warnings that may disappear and return.
Possible causes
- Loose or corroded terminals at the NOx sensor connector high
- Harness near the exhaust damaged by heat or vibration medium
- Intermittent internal fault in the sensor module medium
Symptoms
- Malfunction indicator lamp on, sometimes going out again
- NOx value in live data dropping out briefly
- SCR warning that comes and goes
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2204
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.