P2200
NOx Sensor Circuit (Bank 1 Sensor 1)
P2200 is the general electrical fault reported for the front NOx sensor on bank 1, the unit ahead of the SCR catalyst. Such sensors carry their own control unit, which checks the probe wiring and reports the result over CAN. GM's 6.6L Duramax (LML) sets P2200 as a Type A fault once an open-circuit status keeps arriving for more than 0.5 s or 10 s, depending on calibration. Ford's 6.7L and 3.0L diesels use it for shorts or opens on the probe lines and for memory checksum errors inside the sensor controller. VW's 2014 Touareg TDI reacts to an error message or a validity ratio of at least 0.5. P2201 covers plausibility, P2202/P2203 a value out of range, P229E the downstream sensor. Dosing loses its feedback and the MIL comes on.
Possible causes
- Internal fault in the NOx probe or its attached control unit high
- Damaged cable between probe and sensor control unit (heat, chafing) medium
- Moisture or corrosion in the sensor connector medium
- Unstable supply or ground at the sensor control unit low
Symptoms
- Malfunction indicator lamp on
- No NOx value in live data from the upstream sensor
- SCR or emissions warning, possibly followed by inducement countdown
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2200
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2014/14OBDG10 Engine Diagnostics.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf
- static.nhtsa.gov/odi/tsbs/2014/MC-10074008-2280.pdf
- static.nhtsa.gov/odi/tsbs/2021/MC-10201707-0001.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2